Snell LCR 7
If you're new here, you may want to subscribe to my RSS feed. Thanks for visiting!
The last set of speakers we had in, came in as a demo that were able to play around with for a couple of weeks. The Snell LCR7 is a compact sealed enclosure with dual 5 1/4 mid drivers and a 1″ tweeter.
I only had two of these so could not try out in a 5.1 setup. The imaging was very impressive and they had a very wide sound stage. A few times during movies I almost forgot there was no center channel running. The top end was very detailed and I could see these being an issue in reflective rooms, not bad, but you would want to take note when choosing your electronics or consider some form of room treatments.
As far as output for a relatively small speaker I had no issue with lack of loudness in my room. In fact they played as loud as I would want any speaker to and blended well with my SVS Ultra, no gaps between lows and mids. Powering them with a Marantz 7002 was not an issue either though I would have liked to have had a separate more powerful amp on hand to see the difference between the two with this set.
As these were not mine, I didn’t want to take the grills off. I took a couple of revealing shots of the drivers behind the grill seen below.
Design Acoustic Suspension D’Appolito Array
Frequency Response 75Hz-22kHz +3dB
Sensitivity 90dB
Nominal Impedance 4 Ohms
Crossover Frequency 2.0kHz
Recommended Amplier Power 50-300Watts
Maximum Output (per pair) 110dB
Placement Stand, Wall, or Shelf
Dispersion Angle (+1dB of on axis response) Horizontal: +15 degrees
Vertical: +15 degrees
Drive Units Tweeter: 1-inch SEAS Silk Dome
Woofer: Two 5.25-inch SEAS Treated Paper, 5mm Excursion
Video Shielding Standard
Dimensions Height: 19 -inches
Width: 7-inches
Depth: 8.75-inches
Finishes Cabinet: Real Cherry Veneer
Hand Rubbed Satin Black
Most Wood and Paint Finishes Available
Grille: Silver or Black Perforated Metal 47 % Open
End Caps: Solid Aluminum Plate, Anodized Silver or Black
For purchases and or Bonney Lake home audio installations please contact James Vaughan.
Sound Waves Hifi
425-637-1729
info@soundwaveshifi.com
Services we offer:
-In-wall wiring and on-wall mounting
-Plasma, projector,and screen installation
-Multi -zone audio configuration
-Networking and media streaming
-Complete system calibration (audio/video)
Equipment we specialize in:
-In-room and on In-wall speaker systems
-Subwoofers
-Source components
-Amplification
-Surge protection and line filtering
-Projector, Plasmas, and other displays
-Media furniture, stands, and mounts
And much more!




Discussion Area - Leave a Comment